Struct rusoto_directconnect::BGPPeer

pub struct BGPPeer {
    pub address_family: Option<String>,
    pub amazon_address: Option<String>,
    pub asn: Option<i64>,
    pub auth_key: Option<String>,
    pub aws_device_v2: Option<String>,
    pub bgp_peer_id: Option<String>,
    pub bgp_peer_state: Option<String>,
    pub bgp_status: Option<String>,
    pub customer_address: Option<String>,
}

Information about a BGP peer.

Fields

address_family: Option<String>

The address family for the BGP peer.

amazon_address: Option<String>

The IP address assigned to the Amazon interface.

asn: Option<i64>

The autonomous system (AS) number for Border Gateway Protocol (BGP) configuration.

auth_key: Option<String>

The authentication key for BGP configuration.

aws_device_v2: Option<String>

The Direct Connect endpoint on which the BGP peer terminates.

bgp_peer_id: Option<String>

The ID of the BGP peer.

bgp_peer_state: Option<String>

The state of the BGP peer. The following are the possible values:

• verifying: The BGP peering addresses or ASN require validation before the BGP peer can be created. This state applies only to public virtual interfaces.

• pending: The BGP peer is created, and remains in this state until it is ready to be established.

• available: The BGP peer is ready to be established.

• deleting: The BGP peer is being deleted.

• deleted: The BGP peer is deleted and cannot be established.

bgp_status: Option<String>

The status of the BGP peer. The following are the possible values:

• up: The BGP peer is established. This state does not indicate the state of the routing function. Ensure that you are receiving routes over the BGP session.

• down: The BGP peer is down.

• unknown: The BGP peer status is not available.

customer_address: Option<String>

The IP address assigned to the customer interface.

Trait Implementations

impl PartialEq<BGPPeer> for BGPPeer

fn eq(&self, other: &BGPPeer) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &BGPPeer) -> bool

This method tests for !=.

impl Default for BGPPeer

fn default() -> BGPPeer

Returns the "default value" for a type.

impl Clone for BGPPeer

fn clone(&self) -> BGPPeer

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for BGPPeer

fn fmt(&self, f: &mut Formatter) -> Result

Formats the value using the given formatter.

impl<'de> Deserialize<'de> for BGPPeer

fn deserialize<__D>(__deserializer: __D) -> Result<Self, __D::Error> where
    __D: Deserializer<'de>, 

Deserialize this value from the given Serde deserializer.